Tools required: Torx 6 screwdriver

• Run your fingernail or the edge of a credit card around the join of the top half of the phone to release the clips which hold the front cover on.

• You now have the front cover removed. Now remove the 4 screws you can see.

• In the image below, the screwdriver indicates a ribbon connector which you need to disconnect. It attaches like a plug and socket so simply lift it up to unplug it. Now remove the metal frame. It is attached around the sides by four clips. Use your fingernail or a thin sliver of metal to unclip the frame.

• You can now replace the small LCD screen. Carefully push it away from the metal frame.

• You have now removed the small LCD.

• To remove the large LCD, detach the ribbon connector, indicated by the screwdriver in the picture below. Again, it attaches like a plug and socket so just lift it up to unplug.

• Lift the printed circuit board up and you can then lift the LCD screen away from the phone.

• You will now have removed the LCD screen. Reverse the whole procedure for reassembly.